TN_210_DN - Design Engineering
Design Engineering
  • TN 210-DN-01 - Scour Protection at Base of Risers to Drop Inlet Spillways (8/1967)
  • TN 210-DN-02 - Required 3-Edge Bearing Strength for Rigid Pipe (12/1967)
  • TN 210-DN-03 - Detail of Riprap Above Berm on Earth Dam (7/1968)
  • TN 210-DN-04 - Cradle Modification Where a Rock Foundation Hiatus Exists (8/1968)
  • TN 210-DN-05 - Some Comments on Flexural and Anchorage Bond Stresses (11/1968)
  • TN 210-DN-06 - Riprap Lined Plunge Pool for Cantilever Outlet (Second Edition) (1/1986)
  • TN 210-DN-07 - Variation in Joint Extensibility (8/1969)
  • TN 210-DN-08 - Drop Inlet Entrance Losses (8/1969)
  • TN 210-DN-09 - Use of AWWA C302 Pipe for Principal Spillway Conduits (1/1970)
  • TN 210-DN-10 - Special Designs of Single Cell Rectangular Conduits (6/1970)
  • TN 210-DN-11 - Welding Reinforcing Steel for Reinforced Concrete (1/1971)
  • TN 210-DN-12 - Control of Underground Corrosion (2/1971)
  • TN 210-DN-14 - Cavitation Potential at an Irregularity (1/1973)
  • TN 210-DN-15 - Submerged Weir Flow (5/1973)
  • TN 210-DN-16 - Probability of Occurrence for Certain Design Events (12/1976)
  • TN 210-DN-17 - Some Comments on the Location of Riser Conduit Articulation Joints (4/1977)
  • TN 210-DN-18 - Unattached Engineering Standard Drawings (4/1981)
  • TN 210-DN-18A - Unattached Engineering Standard Drawings, DN-18A, Revised Pages (6/1986)
  • TN 210-DN-18B - Unattached Engineering Standard Drawings, DN-18B, Revised Pages
  • TN 210-DN-19 - Input Data for Design Unit Programs (4/1980)
  • TN 210-DN-20 - Guide to Organization and Operation of Independent Review Boards (4/1980)
  • TN 210-DN-24 - Guide for the Use of Geotextiles (11/1991)
[TN_210_DN - May 2008]